Jeddah · Riyadh · Dammam · Makkah · Est. 2010
Heat exchangers, cooling towers, chillers and HVAC plant for food processors, petrochemical sites, hotels and utilities — designed, fabricated, installed and maintained by one team.
From luxury hotels to petrochemical plants, food processors to power utilities — organisations across the Kingdom rely on GBGCC for critical thermal systems.
From initial design through lifetime maintenance — equipment selected and commissioned to cut running cost, not just to meet the load.
Design, Fabrication & Re-tubing
Custom-engineered shell and tube heat exchangers for process industries — from initial thermal design through precision fabrication, pressure testing, and field re-tubing of existing units.
& Close-Circuit Cooling Towers
Evaporative condensers and closed-circuit cooling towers for refrigeration systems, process cooling, and industrial applications requiring efficient heat rejection with minimal water consumption.
Evaporators, Radiators & Dry Coolers
Air-cooled heat rejection equipment for applications where water availability is limited — from process radiators and dry coolers to refrigeration evaporators and industrial condensers.
Design, Supply, Install & Commission
Complete mechanical, electrical, and plumbing engineering for commercial and industrial facilities — from load calculation and system design through full installation, commissioning, and handover.
Inspection, Rebuild & Recommission
Full overhaul of reciprocating, screw, and centrifugal compressors — disassembly, component inspection, precision rebuild, and recommissioning to restore original performance and extend service life.
& Maintenance
Boiler re-tubing, inspection, and preventive maintenance services for fire-tube and water-tube boilers — restoring thermal efficiency and ensuring safe operation in compliance with applicable standards.
Maintenance & Upgrade
Planned and reactive maintenance for all heating and cooling plant — from routine inspections and filter changes to major component replacement and system upgrades for improved energy efficiency.
The same five steps on every job, whether it is a new cooling tower or a boiler opened for re-tubing. Nothing is sub-contracted out to a name you have not met.
We measure on site — load, footprint, water chemistry, access, and what the existing plant is actually doing rather than what its nameplate says.
Thermal sizing and equipment selection, costed on what the plant will draw over its life rather than on purchase price alone.
Shells, tube bundles, ducting and spares built to drawing, so a replacement matches the plant it is going into.
Rigged, connected, pressure tested and handed over with performance verified against the design figures.
Planned maintenance and breakdown response, with spares held for the plant we already look after.
Cooling tower internals, HVAC plant and duct accessories — held in stock or fabricated to your drawing, measured on site and built to match.
High-efficiency crossflow cooling towers engineered for demanding industrial and commercial applications across Saudi Arabia.
View product
Modular SSS series cooling towers suitable for light commercial and process cooling applications.
View product
Closed-circuit towers keep the process fluid inside a sealed coil, so the plant they serve never sees tower water. Specified where fouling, glycol or water chemistry rules out an open circuit.
View product
Evaporative condensers reject heat at a lower condensing temperature than air alone can reach, on a fraction of the water a once-through system draws. Supplied for refrigeration and process duty.
View productSend the duty, the site and anything written on the nameplate. An engineer replies with questions first, then a costed proposal — no obligation, no generic templates.
Office
No. 23, 6th Floor, Basma Tower
Prince Majid Street, Jeddah 22234
Saudi Arabia
Hours
Sunday–Thursday: 8:00 AM – 6:00 PM
24/7 emergency support available