Skip to content
Blocks of moulded PVC drift eliminator blades in wave, chevron and diamond lattice profiles
Tower Internals & Spares

Tower Internals & Spares

Mist Eliminators

Three-pass PVC drift eliminators that keep water in the tower instead of on the roof, the car park, and your water bill.

Enquire about this productFull catalogue

Part of our Evaporative Condensers service line — we supply, install and maintain it, not just sell it.

Overview

What it does.

Drift is water carried out of the tower as droplets in the discharge air. Unlike evaporation it does no cooling at all — it is pure loss, and it carries the tower’s dissolved solids and any treatment chemical with it.

A three-pass eliminator forces the air through successive direction changes so droplets impact and drain back. Worn or missing eliminators are one of the most common and most easily fixed causes of high make-up water consumption.

Gallery

What it looks like.

Representative units and components. Configuration, finish and connection sizes are built to the order — these show the range, not a fixed model.

Four blocks of moulded PVC drift eliminator blades — wave, chevron and diamond lattice profiles side by side
Blade profiles, left to right: wave, chevron, lattice
Single moulded PVC drift eliminator block seen end-on, showing the sharp zig-zag chevron blade profile through its depth
Chevron profile, end-on
Drift eliminator panel built into a galvanised steel frame, with wave-profile PVC blades set inside it
Framed panel for a tower opening
Specification

The numbers.

Sizes, materials and duty are confirmed against your drawing and a site survey before quotation — nothing here is a fixed catalogue entry.

Technical

Mist Eliminators specification
TypeThree-pass blade
MaterialPVC
Supply formPacks cut to cell dimensions
FittingDrop-in, no adhesive required
Temperature limitUp to 55 °C continuous

Indicative figures. Final specification is confirmed against your duty and site survey at quotation.

Materials of construction

Mist Eliminators materials
BladeRigid PVC
Support framePVC or galvanised steel
Selection

Where it fits.

Applications

  • Cooling tower refurbishment
  • Reducing make-up water consumption
  • Plume and carry-over control
  • Replacing degraded original eliminators

Options & accessories

Cut to bespoke cell sizesHigh-temperature gradeFrame supplied
Same category

More tower internals & spares equipment.

Six PVC fill profiles set out side by side — honeycomb, chevron, cross-flute, vertical-flute and open splash grades

PVC Fills

Structured PVC fill media providing maximum water-to-air contact surface area for efficient heat rejection.

View product
PVC cooling tower spray nozzle with a four-armed splash head above a slotted body

PVC Nozzles

PVC distribution nozzles engineered for uniform water coverage across the fill pack.

View product
Framed cooling tower air inlet louvre panel beside a matching mesh screen panel

Cooling Tower Air Inlet Louvers

PVC air inlet louvers controlling airflow, preventing splash-out, and protecting cooling tower internals.

View product

Ready to start?

Breakdown response and planned maintenance, Kingdom-wide

Seven service lines. One engineering team. Tell us your load, site and timeline — we will come back with a costed proposal.

Get a free quote+966 55 271 0023