PVC cooling tower spray nozzle with a four-armed splash head above a slotted body

Tower Internals & Spares

PVC Nozzles

Distribution nozzles that put water evenly across the whole fill face — because a tower only uses the fill the water actually reaches.

Enquire about this product Full catalogue

Part of our Evaporative Condensers service line — we supply, install and maintain it, not just sell it.

Overview

What it does.

Uneven distribution is a quiet efficiency killer. Where nozzles are blocked or missing, that section of fill sees little water and contributes almost nothing, while the rest is overloaded. The tower is then working at a fraction of its installed surface area with no obvious fault.

Non-clog designs and a gravity basin that can be inspected without dismantling anything are what keep distribution even over years rather than months.

Gallery

What it looks like.

Representative units and components. Configuration, finish and connection sizes are built to the order — these show the range, not a fixed model.

Grey PVC spray nozzle with a four-armed splash spreader above a slotted lobed body — Splash-spreader nozzle

PVC target nozzle assembly on a cross-shaped manifold with four flanged branch outlets — Cross-manifold target nozzle

White PVC nozzle body with a grey angled inlet elbow and side branch connection — Angled-inlet nozzle body

Specification

The numbers.

Sizes, materials and duty are confirmed against your drawing and a site survey before quotation — nothing here is a fixed catalogue entry.

Technical

PVC Nozzles specification
Type	Gravity and low-pressure spray
Design	Non-clog, wide orifice
Fitting	Push-fit into basin, removable by hand
Spray pattern	Full cone
Temperature limit	Up to 55 °C continuous

Indicative figures. Final specification is confirmed against your duty and site survey at quotation.

Materials of construction

PVC Nozzles materials
Body	PVC or ABS
Target plate	PVC

Selection

Where it fits.

Applications

Cooling tower refurbishment
Correcting uneven fill wetting
Replacing blocked or missing nozzles
New tower build

Options & accessories

Alternative orifice sizesAnti-clog target plateBasin grommets

Same category

More tower internals & spares equipment.

Blocks of moulded PVC drift eliminator blades in wave, chevron and diamond lattice profiles

Mist Eliminators

High-efficiency PVC mist eliminators minimising water carry-over and drift losses from cooling towers.

View product

Six PVC fill profiles set out side by side — honeycomb, chevron, cross-flute, vertical-flute and open splash grades

PVC Fills

Structured PVC fill media providing maximum water-to-air contact surface area for efficient heat rejection.

View product

Framed cooling tower air inlet louvre panel beside a matching mesh screen panel

Cooling Tower Air Inlet Louvers

PVC air inlet louvers controlling airflow, preventing splash-out, and protecting cooling tower internals.

View product

Ready to start?

Breakdown response and planned maintenance, Kingdom-wide

Seven service lines. One engineering team. Tell us your load, site and timeline — we will come back with a costed proposal.

Get a free quote +966 55 271 0023